My second PDP-8/M is just about back in the land of the living. I followed largely the same process as with the restoration of my first 8/M. Luckily this examples case wasn’t corroded and so I didn’t bother respraying and left it in original condition.

The main sticking point with getting this machine back was a failed +5V and +15V rail on the PSU. Being no expert on PSUs and having been mildly ‘warning’ zapped by it when I decided to see if anything obvious was failed, I had a hunt for a company to perform the repair.

I opted for Electronic Repair Centre Limited after some internet searches. I was very impressed with their service, which was fast and very well priced. I thoroughly recommend them to anyone looking to get a power supply repaired.

After getting the PSU back, I reassembled the machine and with a bit of CPU board swapping (3 of the originals turned out to be failed), I now have a mostly working machine. The one gotcha I currently have is that on entering the DEC accumulator counting test, the accumulator counts at full bore and cannot be seen neatly increasing on the console. My suspicion is that the line time clock might be the cause of this.

The investigation continues…

Having reinstalled the power supply into the chassis, the console was put back into slot 1 and carefully reassembled.

The minimum board set was then installed consisting of:

• Slot2: M8330 KK8-E timings
• Slot3: M8300 KK8-E major registers
• Slot4: M8310 KK8-E major register control
• Slot 20: M8320 KK8-E bus loads

The machine was then powered on and LEDs on the console sprung into life. Some basic operation from the console was possible (I was able to set the PC) although bit 5 of the PC appears to be stuck off. I will have to investigate whether this is a fault on the console or not.

I also installed an 8KW core memory set and retested with this in place. With these boards in place, the PC was all bits high and could not be changed.

So still some way to go! The next step will be to establish if the KK8-E is fully working and track down the issue that is causing the bit 4 of the address bus to appear stuck low on the console.